JDM Parts,Performance Auto Parts

Customer Review & Ratings

STI
PUSH ENGINE SWITCH
(Japanparts No : 1008P-003-001)

Average 5

Rating Breakdown

All Stars

5 Stars	100
4 Stars
3 Stars
2 Stars
1 Star

< | 1 | 2 | 3 | 4 | >

Written by Eric C. (GUAM)
2024-04-17

- Product Review
Very nice touch if you want the JDM goodies for your OEM plus Subaru!

- Photo

Written by Kalum (AUSTRALIA)
2023-06-28

- Product Review
Great JDM STI product - High quality and perfect fit as expected from Subaru/STI.

Written by Steve (AUSTRALIA)
2023-06-08

- Product Review
Genuine sti part. Nice additional to interior. Quality part. Glows at night.

- Photo

- Installation tips
Installed on sti va. No need to remove any interior. Remove fuse cover and route your hand to the back of the push start button. It is held with 2 clips. Squeeze and push forward and your button slides out. Plug is also held with clip. Easy install

Written by Michael (UNITED STATES)
2023-03-28

- Product Review
Great touch to add to your STi interior. Easy to install. Took me 5 minutes without instructions.

Written by Ryan (UNITED STATES)
2022-10-30

- Product Review
2022 Forester Sport. Looks awesome and should be install from factory.

- Installation tips
Easy install, remove side cover of dash to reveal screw and also one screw on lower right in foot well. Once unscrewed, pull out lower portion of dash and then there is a small portion above that to remove. Once out, reach back behind start button, squeeze prongs and it will come forward. Release wire harness and plug STI start button in and slide it in
Just reverse the directions to put back together. Really easy.

Written by Benjamin (UNITED STATES)
2022-10-26

- Product Review
Excellent upgrade and works perfectly on US Spec '21 STI. Plug and play, easy install and Japanparts.com is the best place to buy!

- Photo

- Installation tips
100% plug and play on US spec '21 STI.

Written by Louie (PHILIPPINES)
2022-08-07

- Product Review
Awesome STI piece for the interior. Red definitely pops as an accent piece. The words “ENGINE START STOP” illuminates, while the “STI” scrip on top does not.

- Photo

- Installation tips
Easy install, 1 screw at the bottom, 2 panels pulls straight out. The button module pops out easy as well, just unplug the wiring socket at the back and pop in the new one.

Written by Florian (SWITZERLAND)
2022-05-05

- Product Review
Looks way better than the original black start button

- Installation tips
Plug and play

Written by douglas (UNITED STATES)
2021-07-26

- Product Review
that jdm oem spec like the car should have came

Written by W (UNITED STATES)
2019-10-14

- Product Review
Great replacement of the stock black push button switch, looks really sharp and goes well with other STI interior parts.

- Photo

- Installation tips
Simply remove the screw holding the side panel and the bottom panel below the steering wheel. Then carefully pull out the side panel, then the ignition switch trim. Push the switch out from behind, and then unplug the electrical wiring. To install the new switch simply reverse the instruction order. Did it in 10 mins.