JDM Parts,Performance Auto Parts

Customer Review & Ratings

Subaru
VISOR, COMBINATION METER
(Japanparts No : 484-023-001)

Average 4.9

Rating Breakdown

All Stars

5 Stars	90
4 Stars	10
3 Stars
2 Stars
1 Star

< | 1 | >

Written by Reece (UNITED KINGDOM)
2021-01-06

- Product Review
Nice upgrade to the plastic part that is replaced, great quality stitching.

- Installation tips
Just one screw to remove on the instrument binnacle, then pull up and out on the old piece to remove it.

Written by Francesco (ITALY)
2019-11-14

- Product Review
Perfect finish and installation.

- Photo

- Installation tips
the installation takes a few minutes, unscrew the single screw, remove the old cover, put the new cover and screw it again

Written by Joel (CANADA)
2018-03-16

- Product Review
Made my interior look more luxurious and worthy! I found a tiny knick in mine but not too noticeable. Install was easy and I love the higher points the top of this piece.

- Installation tips
simply remove the one screw holding visor in, pull forward and up. Make sure new one is seated correct and push in before installing tapping screw again.

Written by brandon (UNITED STATES)
2017-08-30

- Product Review
Looks great with the red stitched interior of the fr-s monogram edition.

- Installation tips
Installation is pretty simple. Remove the screw under the hood and pop the old hood out. Snap on the new one and put the screw back.

Written by Jared (PHILIPPINES)
2017-04-23

- Product Review
It's made from high quality alcantara leather. I just really love it. I recommend this to you 10/10

- Installation tips
You need a short screwdriver to take off the bolt locking the visor up.

Written by Bounyong (UNITED STATES)
2016-04-01

- Product Review
Great piece for my USDM BRZ and a great price. Nice in quality in fit and finish, the major difference is that it has to fins that protrude more than OEM which gives it aggressive look. Nice start out to my BRZ TS conversion.

- Installation tips
When installing into USDM/Right hand drive model, pull from the bottom right gauge hood cover and pull it at a 45 degree angle it will slowly come out and when installing the TS gauge hood cover make sure all tabs are in the correct seating position or it will not seat correctly.

Written by Justin (UNITED STATES)
2016-01-30

- Product Review
Fantastic fit and finish. It takes away virtually all the glare on the windshield. For the price, it is one of the best add ons you can buy.

- Installation tips
AFter removing the screw from underneath (by the gauges) pull up and out and it will slide right out. When installing, if the tabs don't fully go in, just give it a little love tap.

Written by CHRISTOPHER (CANADA)
2015-12-21

- Product Review
Very nice material to replace the standard plastic piece. Red stitching matches with the rest of the BRZ interior. Fitment is perfect and install is easy. 1 screw to remove. Pull out the old, pop in the new.