JDM Parts,Performance Auto Parts

Customer Review & Ratings

STI
GURNEY FLAP
(Japanparts No : 484-001-011)

Average 5

Rating Breakdown

All Stars

5 Stars	100
4 Stars
3 Stars
2 Stars
1 Star

< | 1 | >

Written by John (UNITED STATES)
2020-08-12

- Product Review
Great Fitment & Quality Product. Gives a complete appearance towards the rear spoiler.

- Photo

- Installation tips
Easy installation. No drilling necessary. Would advise to use soap + water & rubbing alcohol to clean thoroughly the rear spolier before placing the 3M Tape attached to the STi Gurney Flap. With the additional clips included, you can cut the clip to fill in the holes on the STi Gurny Flap and add a small amount of 3M Adhesive on the surrounding clips. STi Sticker needs to be crucially install carefully, otherwise it will be very difficult to remove. Use a measuring tape to measure both ends of the Gurney Flap and find the center point. Add auto/painters tape from the center point lines and use tweezers to carefully add the STi sticker between the center point lines.

Written by Pawel (POLAND)
2018-05-20

- Product Review
Easy upgrade, looks very nice. Only STI sticker is disappointing - you must be very careful when you install it, it is very difficult to remove it and glue it again, sticker would be probably damaged.

- Photo

- Installation tips
Very install to glue it, even if it came rolled, after you start to glue everything goes well. It is recommended to drill the spoiler and use included pins, but I decided to keep it glued without drilling (see the photos). You may install pins just to hide the holes, but you need to cut them in the half.

Written by Kevin (CANADA)
2018-03-30

- Product Review
Great fit and easy to install. Looks great.

- Installation tips
Can cut plastic screws to the correct size if you prefer not to drill holes in the spoiler. This way it is still very stable with the adhesive.

Written by Joel (CANADA)
2018-03-16

- Product Review
Awesome product! Installed like a breeze and added a nice touch to my BRZ STI tS conversion! would strongly recommend. My only gripe was the cheap STI sticker that came with it. I ended up buying a Replica STI Chiclet to mount instead and it looks more flashy and expensive!

- Installation tips
Clean top edge of your spoiler with soap/ water and then clean with rubbing alcohol. Let flash dry and allow a few minutes before mounting. For a better fit, Use a heat gun on low of a hair dryer on mid-high to soften the rubber material and mock align. when happy, start one of side and remove approx 2-3 inches of adhesive backing at the side. Once complete, press down on the spoiler to better bond adhesive. I would suggest letting the adhesive bond without driving for atleast a few hours. The push clips can be used but would require drilling two holes into the spoiler. I cut the clip piece off and used adhesive to tape the push caps in place. Once complete mount your STI sticker and enjoy!

Written by Ryan (UNITED STATES)
2016-02-02

- Product Review
Quality part and fits perfectly! Easy install with supplied instructions despite being in Japanese. Does not require drilling of holes.

- Installation tips
Measure and mark distances per the supplied instructions. Be sure to measure for placement of center sticker as there are no markers for placement. If installing without drilling of holes, cut plastic tabs in half and insert into holes in flap.