Great Fitment & Quality Product. Gives a complete appearance towards the rear spoiler.
- Photo
- Installation tips
Easy installation. No drilling necessary. Would advise to use soap + water & rubbing alcohol to clean thoroughly the rear spolier before placing the 3M Tape attached to the STi Gurney Flap. With the additional clips included, you can cut the clip to fill in the holes on the STi Gurny Flap and add a small amount of 3M Adhesive on the surrounding clips. STi Sticker needs to be crucially install carefully, otherwise it will be very difficult to remove. Use a measuring tape to measure both ends of the Gurney Flap and find the center point. Add auto/painters tape from the center point lines and use tweezers to carefully add the STi sticker between the center point lines.
Written by John (UNITED STATES) | 2020-08-12
- Product review
Easy upgrade, looks very nice. Only STI sticker is disappointing - you must be very careful when you install it, it is very difficult to remove it and glue it again, sticker would be probably damaged.
- Photo
- Installation tips
Very install to glue it, even if it came rolled, after you start to glue everything goes well. It is recommended to drill the spoiler and use included pins, but I decided to keep it glued without drilling (see the photos). You may install pins just to hide the holes, but you need to cut them in the half.
Written by Pawel (POLAND) | 2018-05-20
- Product review
Great fit and easy to install. Looks great.
- Installation tips
Can cut plastic screws to the correct size if you prefer not to drill holes in the spoiler. This way it is still very stable with the adhesive.