JDM specialist Japanparts.com

Spec: Twin plate. Metal disc. With damper. Actuation - Pull type Diameter - 200mm Clamp load (N) -9800 Attachment: F/W bolt Additional parts required: Pilot Bearing Features: From high power tuned drag race to street usage, the EXEDY multi plate is capable of handling a variety of motor sport applications. -Center plate self-leveling function(PAT.)- The amount of center plate travel during release is always maintained in a neutral position by the reaction force of the lifting plate attached to both sides of the center plate. -Pull type clutch cushioning function(PAT.)- * The “CUSHION” function is a new innovation unique to EXEDY. * The half engaged “ZONE” is expanded as a result of a decrease in rigidity of the pivot ring. * Ideal pedal effort is achieved as a result of a longer lever ratio of the diaphragm spring coupled with the cushion reaction force.

Front pair price. About 15mm down than original. <a href="https://www.sti.jp/en/parts/subarubrz_zc/suspension/ST20330AS000/" target="new"><img title="" src="http://capture.heartrails.com/200x100/shorten?https://www.sti.jp/en/parts/subarubrz_zc/suspension/ST20330AS000/" alt="https://www.sti.jp/en/parts/subarubrz_zc/suspension/ST20330AS000/" width="200" height="100" /></a>

Rear pair price. About 15mm down than original. <a href="https://www.sti.jp/en/parts/subarubrz_zc/suspension/ST20330AS000/" target="new"><img title="" src="http://capture.heartrails.com/200x100/shorten?https://www.sti.jp/en/parts/subarubrz_zc/suspension/ST20330AS000/" alt="https://www.sti.jp/en/parts/subarubrz_zc/suspension/ST20330AS000/" width="200" height="100" /></a>

Pair price (57521+57521A). STI T/S and A-line (wingless use model) use.

The front wide fenders are 20mm wider on each side allowing for a much wider choice of tire and wheel sizes. A special extension panel on the side of the front bumper is included to eliminate the gap between the fender and the front bumper and a special liner is also included to compensate for the lack of coverage of the factory inner fenders due to the widening. (*We recommend using with carbon LED mirrors due to the design to remove the side blinkers. *Type 1 is applicable for Top Secret Full Bumper Kit Ver.1/Ver.2 and MY2008-MY2010 Nissan OE Front Bumper.

Carbon. Only for SE3P earlier model (ZENKI). We have received a lot of comments from the customers about the quality of the carbon products of RE-Amemiya. So cancellation or replacement of their carbon products is not possible.

This product's metal elegance and central TRD logo bring sports spirit and quality to the engine room. It features a hole for a spring lock in anticipation of motor sports applications. Fitting a spring lock is also possible. This item was specially designed due to differences in screw pitch, size, etc. with existing Toyota vehicles. Let your care and attention extend to the oft-unseen engine room with this item. This item cannot be installed on Toyota vehicles other than Toyota 86.

For Gasoline models without indicator models

Increasing the pressure inside the radiator to raise the boiling point (by increasing the valve opening pressure of the radiator cap) will control air bubbles. This improves the cooling effect and optimizes the radiator's cooling function. Relief pressure 127kPa(1.3kgf/cm2). Recommended for use in driving environments where the engine exerts high RPM (such as winding roads and racing circuits).

Aluminum oval shaft. Brackets and Shaft connecting are bushes.