Average 5.0
Total 3 reviews
Rating Breakdown
All Stars5 Stars | 100 |
---|---|
4 Stars | |
3 Stars | |
2 Stars | |
1 Star |
Fit well. Look good on white doors.
Easy to install, way easier than those clear ones. Also practical, no need to worry scratches from finger nails anymore.
1. Prep the protector. Cut the base film (milky white) horizontally into two parts and put it back.
2. Prep the handle "well". Clean it and degrease it. I use rubbing alcohol to degrease. The instruction mentioned that installation should be undertake above 15 degrees C. If you try to install in cold days, warm up the well and the protector before installation.
3. Roll the protector to suit the well shape.
4. Test fit the protector. Press in the middle first then spread around.
5. Remove the upper base film and install the protector. Press from below the horizontal middle line and spread around the upper portion of the protector.
6. Remove the lower base film and press from above the middle line and spread around the lower portion of the protector.
7. Remove the upper protection film(clear).
Excellent product and a must needed door handle pocket protection! and easy to install
Clean the area of application. Peel off front clear cover, bend product to match contour of door pocket, peel off adhesive side. Spray water mist on door handle pocket and the back side of door protector so product can be moved or centered. When desired position is achieved, firmly press from center towards the top and center to bottom.